User canceled an operation Could not find HMenu's parent in MenuKey Menu bar definition procedure not found Insufficient memory to update a pixmap Server volume has been disconnected Wrong volume type Move into offspring No free WCB avaible Directory not found Memory block is locked Size check failed Block check failed Pointer check failed Address in zone check failed Attempt to purge a unpurgeable block Attempt to operate on a free block Address was odd or out of range NIL master pointer Memory full, not enough room in heap zone No data of the requested type Desk scrap isn't initialized Error in read only zone Driver open error, port not configured for this connection Driver open error, port already in use Excessive collisions, ALAP no CTS received after 32 RTS's, or line sensed in use 32 times Lap protocol error, ALAP error attaching/detaching ALAP protocol type No bridge found DDP datagram of ALAP data length too big DDP socket error SCC break recived SCC framing or parity error InitUtil found PRAM not initialized Parameter RAM written did not verify Time written did not verify Unable to read clock Track failed to verify Can't get enough sync Can't find sector 0 after track format Can't find sector Track number wrong on address mark Can't correctly adjust disk speed Tried to read side 2 of a disk in a single-sided drive Can't intialize disk controller chip Can't find track 0 Drive error Write underrun occurred Bad data mark Bad data mark Can't find a data mark Bad address mark Bad address mark Read-verify failed Can't find an address mark Disk is probably blank No disk in drive Drive is not connected Write permission error, read/write permission doesn't allow writing Bad master directory block, must re-initialize volume Problem during rename External file system, file-system identifier is non-zero Not a Macintosh disk, volume lacks Macintosh-format directory No such drive, specified drive number doesn't match any number in the drive queue Specified volume is already mounted and on-line Permission error, attempt to open locked file for writing Volume not on-line Error during GetFPos Reference number error or path reference number error Error in parameter list Open write error, no read/write permission Duplicate file name, file with specified name and version number already exists File is busy, one or more files are open Volume is locked by a software flag File is locked Write protect, volume is locked by a hardware setting File not found Too many files open Memory full or file won't fit Attempt to position before start of file Logical end-of-file reached during read operation File not open Bad file name or volume name (perhaps zero-length) I/O error No such volume, specified volume doesn't exist Disk full, all allocation blocks on the volume are full File directory full Device control entry can't be extended Unit table is full Driver isn't open I/O request aborted by KillIO Couldn't find driver in resource file Attempt to remove an open driver Driver can't respond to Close call Requested read/write permission doesn't match driver's open permission Driver reference number specifies NIL handle in unit table Driver reference number doesn't match unit table Driver can't respond to Write call Driver can't respond to Read call Driver can't respond to this Status call Driver can't respond to this Control call Try to set a protected entry Set entry out of range No room error in make i table Over run error in make i table Table allocation error in make i table Queue allocation error in make i table No color to index match iTabPurgErr No debugger installed to handle debugger command Unimplemented core routine Core routine number out of range QType field of entry in vertical retrace queue isn't vType Entry not in queue